All kinds of elbow fittings of cable tray are generally ordered by the manufacturer. The defects made on site are: first, they are not beautiful, second, they are not used (especially spraying and hot-dip galvanizing), and third, they are time-consuming. In particular, some project supervisors are not allowed to process on site. Therefore, users usually make a list in advance according to the construction drawings, and then directly install them after being ordered by the manufacturer.

电缆桥架装置过程中，用到的弯头一般有三种：一种是水平弯，一是笔直上下弯，还有一种是"之"字弯。以下举例说明这些弯头制作办法及公式：例：400×150的桥架做45°"之"字弯从桥架旁边面取15cm×0.8在桥

In the process of cable tray installation, there are generally three kinds of elbows: one is horizontal bending, one is straight up and down bending, and the other is "zigzag" bending. The following examples illustrate the manufacturing methods and formulas of these elbows: example: 400 × A 45 ° "zigzag" bend shall be made for 150 bridge, and 15cm shall be taken from the side of the bridge × 0.8 at the bridge

然后三个点衔接就成一个45°的等腰三角形（另一边用同一办法），然后将这个三角切掉就构成一个45°弯，然后再用要做的高度×1.41为里面的极点再画三角形，方向与前面那个相反，做出来便是一个45°之字弯。90°弯是取要做的那一面的2倍画三角。

Then the three points join to form a 45 ° isosceles triangle (the other side uses the same method), then cut off the triangle to form a 45 ° bend, and then use the height to be done × 1.41 draw a triangle for the inner pole. The direction is opposite to the previous one. It is a 45 ° zigzag. The 90 ° bend is to take twice the side to be made and draw a triangle.

总结出来的公式：比方45度的斜度弯头，你只需记住这句话就知道怎样做了"爬坡45度，桥架高度乘以0.8平分划三条线为一个弯，斜边是爬坡高度乘以1.41,30度是桥架高度乘以0.8除以45乘以30平分划三条线为一个弯。

For example, for a 45 degree slope elbow, you only need to remember this sentence to know how to do "climbing 45 degrees, the bridge height multiplied by 0.8 bisects three lines as a bend, the slope is the climbing height multiplied by 1.41, and 30 degrees is the bridge height multiplied by 0.8 divided by 45 times 30 bisects three lines as a bend.