Cable bridge, as the electrical protection system in buildings, has good anticorrosion performance. The cable bridge factory is most familiar with the specific anti-corrosion treatment operation process. Want to understand the anticorrosion process of cable tray, follow us to explore it!

电缆桥架的防腐能力直接影响着产品质量的高低和使用寿命，因此对桥架进行防腐处理是必须的。电缆桥架厂家会在现场采用砂轮机除锈，其除锈的级别必须达到ST3级，表面经过除锈后，在4小时内涂抹上底漆，当发现有新锈时，还要重新再处理。

The anti-corrosion ability of cable tray directly affects the product quality and service life, so it is necessary to carry out anti-corrosion treatment for cable tray. The cable tray manufacturer will use a grinder to remove rust on site, and the derusting level must reach ST3. After derusting, the surface should be coated with primer within 4 hours. When new rust is found, it should be treated again.

粉刷涂层时，层间要纵横交错，每层都要往复的均匀涂抹，不能出现漏漆的现象，因为只有稀释的规定的浓度，才能更符合厂家的生产标准。我厂在配制时，将涂料搅拌均匀后，使用200目铜丝网过滤使用，当开通后将剩余的涂料密封保存。

When painting the coating, the interlayers should be crisscross, and each layer should be applied evenly and reciprocally. The phenomenon of paint leakage is not allowed, because only by diluting the specified concentration, can it meet the manufacturer's production standards. In the preparation of our factory, after mixing the coating evenly, use 200 mesh copper wire mesh to filter and use, and seal the remaining coating after opening.

我们电缆桥架厂在生产的时候，对温度有严格的把控，温度一般要控制在12-30摄氏度，在进行质量检查之前会行桥架防腐能力的检测，只有该工序合格才能进行下面的生产工序。

During the production, our cable tray factory strictly controls the temperature. Generally, the temperature should be controlled at 12-30 ℃. Before the quality inspection, the anti-corrosion ability of the cable tray will be tested. Only if the process is qualified, can the following production process be carried out.